Yealink SIP-T20 User Manual download pdf (Page 28)

User Guide for the SIP-T20P/SIP-T20 IP Phone

To configure PPPoE via phone user interface:

1. Press .

2. Select Settings->Advanced (password: admin) ->Network->WAN Port.

3. Press to select IPv4 and press .

4. Press to select PPPoE and press .

5. Enter the user name and password in the corresponding fields.

6. Press to accept the change.

Note

Generally, your phone will be deployed with multiple other phones. In this case, your

system administrator will configure the phone parameters beforehand, so that after you

start up your phone, the phone will be registered and ready for use. If your phone is not

registered, you may have to register it. For more information on how to register your

phone, refer to Account Management on page 43.

If the phone has successfully started up, the idle screen will be shown as below:

The idle screen shows the label of current account, time and date.

Wrong network settings may result in inaccessibility of your phone and may also have an

impact on your network performance. For more information on these parameters,

contact your system administrator.

1234

17 Jan 09:20

1. PPPoE User:

2aB

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 125 126

No comments

Yealink SIP-T20 User Manual Page 28