Yealink SIP-T20 User Manual download pdf (Page 82)

User Guide for the SIP-T20P/SIP-T20 IP Phone

2. Enter the number you want to transfer the call to.

3. Press or to dial out.

4. After the party answers the call, press to complete the transfer.

If you are using a handset, the transfer can be completed by hanging up the handset.

You can cancel the transfer before the call is connected by pressing .

You can enable or disable call waiting on the phone. If call waiting is enabled, you can

receive another call when there is an active call on the phone. Otherwise, another

incoming call is automatically rejected by the phone with a busy message when there is

an active call on the phone. You can also enable or disable the phone to play a warning

tone when receiving another call.

To configure call waiting via phone user interface:

1. Press .

2. Select Fe atures->Call Waiting.

3. Press or to select Enable from the Call Waiting field.

4. Press or to select Enable from the Play Tone field.

5. (Optional.)Enter the call waiting on code and off code respectively in the CW On

Code and CW Off Code field.

6. Press to accept the change.

Call waiting is configurable via web user interface at the path Fe atures->General

Information.

You can create a conference with other two parties using the phone’s local conference.

You can create a conference between an active call and a call on hold (on the same or

another line) by pressing the CONF key.

Note

Network conference is not available on all servers. For more information, contact your

system administrator.

1. Call Waiting:

◄ *Enable ►

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 125 126

No comments

Yealink SIP-T20 User Manual Page 82