Yealink SIP T46G Specifications download pdf (Page 152)

User Guide for the SIP-T46G IP Phone

140

2. Press the Hold soft key to place the current multicast RTP session on hold.

3. Press the End Call soft key to cancel the multicast RTP session.

Note

To send RTP stream via a paging key list:

1. Press the paging list key when the phone is idle.

2. Press or to select the desired group.

3. Press or the Paging soft key to send RTP.

4. Press the Hold soft key to place the current multicast RTP session on hold.

5. Press the End Call soft key to cancel the multicast RTP session.

You can configure the phone to receive a Real Time Transport Protocol (RTP) stream from

the pre-configured multicast address(es) without involving SIP signaling. You can

specify up to 10 multicast addresses that the phone listens to on the network.

How the phone handles incoming multicast paging calls depends on Paging Barge and

Paging Priority Active parameters configured via web user interface.

Paging Barge

The paging barge parameter defines the priority of the voice call in progress. If the

priority of an incoming multicast paging call is lower than that of the active call, it will be

ignored automatically. If Disabled is selected from the pull-down list of Paging Barge,

the voice call in progress will take precedence over all incoming multicast paging calls.

Valid values in the Paging Barge field:

 1 to 10: Define the priority of the active call, 1 with the highest priority, 10 with the

lowest.

 Disabled: The voice call in progress will take precedence over all incoming paging

calls.

Multicast RTP is one way only from the sender to the multicast address(es) (receiver). For

outgoing RTP multicasts, all other existing calls on the phone will be placed on hold.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 181 182

No comments

Yealink SIP T46G Specifications Page 152